The useful distinction
Understand the requirement.
Place a USB peripheral beyond a short desk cable while preserving its documented USB mode and power requirements. [C980A]
Bounded facts, visible unknowns
Specifications and limits
| Documented task / mode | Up to 5Gbps USB 3.2 Gen1; the manufacturer separately documents USB2.0/1.1 backward compatibility. [C980A] |
|---|---|
| Construction / length | Active copper extension with fully shielded cable and PVC jacket; no optical conversion is represented. 10m exact assembly; the sheet allows up to two of this model cascaded, totaling 20m. Do not extend that allowance to arbitrary repeaters. [C980A] |
| Verified device list | Not included. Check exact device and accessory documentation. |
Active copper extension with fully shielded cable and PVC jacket; no optical conversion is represented. No in-wall, plenum, wet-location or continuous-flex approval is established here. Plan clearance for the active housing and the specified supply.
Before you connect
What to check
- Record device model, USB enumeration speed, supply connection and every additional cable. If the direct short path works but the extension does not, compare one supported component and send the exact topology to support.
- Check condition with power disconnected where the equipment guidance permits; stop for damage, heat or unknown powered connections.
- Keep published source support separate from physical test results.
Direction and fallback
Connect the plug to the computer and the receptacle to the peripheral's suitable USB cable; this is an extension of a host/device path. USB2.0/1.1 support is documented. Actual enumeration and speed still depend on the complete device path.
Worked selection example
For a documented USB3 camera 10m from a computer, place the extension's plug at the host and its receptacle at the camera cable. Confirm camera power and supported topology before comparing enumeration.
What to observe next
Record device model, USB enumeration speed, supply connection and every additional cable. If the direct short path works but the extension does not, compare one supported component and send the exact topology to support.
Your next step
Move from the form to the requirement.
The source trail
Evidence for this page
AI-assisted inspection is not independent engineering review. Source scope and access limitations are disclosed below. Procedural checklists are editorial requirements, not hardware measurements.
Up to 5Gbps USB 3.2 Gen1; the manufacturer separately documents USB2.0/1.1 backward compatibility. Bus-powered circuitry; included external adapter may power the device path when needed. The adapter is specified as 5V DC, 2A; that is not a 2A allocation promise at every peripheral. Active copper extension with fully shielded cable and PVC jacket; no optical conversion is represented. 10m exact assembly; the sheet allows up to two of this model cascaded, totaling 20m. Do not extend that allowance to arbitrary repeaters.
StarTech.com · USB3AAEXT10M datasheet ↗S1100: full source recordInspect review dependencies →